DL ProFused Spool Clapton resistive wire spool in Ni80 by Breakill's Alien Lab in collaboration with Suprema Ratio.
Ideal product for preparing custom complex coils for Open Lung vaping in DL on rebuildable atomizers.
This wire offers resistive values intermediate between Flavour coil and Cloud coil, ensuring better flavor production at high wattages. Recommended for use in Dual Coil.
The metal packaging contains a roll of 2 meters of wire.
Breakill's Spools Suprema Ratio DL Pro Fused Resistant Wire for Complex Coils
The DL Pro Fused Spool coil from Breakill's Alien Lab is a spool on which 2 meters of resistant wire Clapton are wound: a bundle of Nichrome 80 wires produced by Suprema Ratio, as thin as hair, expertly hand-woven by the Coil Builder artisan.
The result is a "braid" formed by a Core and a Wrap, to be wound in turns on a metal rod to create custom e-cigarette resistances, installable on rebuildable atomizers for Direct Lung use.
Thanks to its structure, it offers an enhanced aromatic yield at high wattages and an Ohm value halfway between the Flavour and Cloud coil. Recommended for use in Dual Coil. Given its structure, it is also possible to obtain extreme setups, suitable ONLY for parallel batteries or 21700 batteries.
The DL Pro Fused Spool wire coils guarantee maximum cleanliness thanks to the double ultrasonic wash they undergo after assembly (which is done manually) and the metal case in which they are supplied.
Efficient, versatile and without residual processing oils: the best of the best for your RBA atomizers!
Designed for experienced vapers: do not use setups that are too low on mechanical mods and with inadequate batteries.
Recommended Single Coil Setups
4@ 3mm rod = 0.023?
5@ 3mm rod = 0.27?
Recommended Dual Coil Setups
4@ 3mm rod = 0.09?
5@ 3mm rod = 0.11?
4@ 3.5mm rod = 0.11?
5@ 3.5mm rod = 0.11?
Technical Specifications
Draw Type: Direct Lung
Material: Ni80
Linear Resistivity: 3.4 ?/m
Recommended Atomizers: RTA, RDA
Instructions for Use
Cut a piece of Clapton wire of the desired length with wire cutters
Consult the list of recommended setups to know in advance the Ohm resistance value of the coil you want to assemble
Wrap the wire around a metal rod (coil jig) with the chosen diameter and number of turns
Place the coils on the atomizer deck
Tighten the coil legs in the appropriate anchor points
Cut off the excess with wire cutters
Perform several dry burns at a low wattage (half of the recommended wattage) before inserting the cotton, and check that the coil heating is uniform (see tutorial section)
Place a generous amount of cotton inside the coils and trim it to fit properly
Moisten the cotton with e-liquid and activate the coils a few times to check their correct operation
Close the atomizer and refill the e-liquid (if necessary)
Maintenance: perform a dry burn (dry activation without cotton) every 15-20ml of vaporized e-liquid
Breakill's Spools Tutorial
Package Contents
1 x DL Pro Fused Spool Breakill's Alien Lab 2mt
1 x Metal case
Buy Breakill's resistive wires on Svapoebasta
In the shop you can find all the products for regenerating Breakill's Alien Lab: take a look at the complete catalog and choose between prefabricated coils and artisanal resistive wires made in Italy!