Hellvape Seri RDA Rebuildable Dripper Atomizer for Lung Vaping
The Seri RDA by Hellvape is a rebuildable atomizer for lung vaping with a diameter of 26mm and a 510 connector. It can be used as a regular dripper with the classic pin or for bottom feeding (BF) vaping thanks to the pre-installed squonk pin.
Made of high-quality stainless steel, this device features a rebuildable deck that can accommodate two or three coils, allowing for high-wattage sub-ohm vaping. Three Ni80 coils with a resistance of 0.2? each (with accompanying cotton) are included in the package. When used in dual coil mode, a metal separator must be installed in the center to complete the electrical circuit.
The liquid wells are very deep (6mm), which helps keep the cotton well saturated both in BF and dripping setups. The airflow hits the coils from the side, providing a large amount of dense vapor, excellent flavor production, and adjustable airflow through the Outer AFC Cap, the outermost section that covers the bell.
The 810 drip tip is very practical and can be replaced if desired.
This electronic cigarette atomizer is quite unique and designed to handle very low resistance values and series-connected coils. Therefore, it is recommended for experienced vapers and should be used with dual battery box mods.
Available in various colors.
Instructions for Use
- Screw the atomizer base onto a box mod with a 510 connection. If using a bottom feeder mod, install the included BF pin.
- Install two or three coils in the deck as shown in the image below, securing them by tightening the screws with the included hex key. Alternatively, use pre-made coils.
- If using a dual coil setup, insert the center connector to complete the circuit (it will not function without it).
- Insert the cotton wicks into the coils and place them on the bottom of the deck, ensuring the wells are well-filled and trimming the excess wick.
- Saturate the cotton with e-liquid and perform a few test activations.
- Close the atomizer, adjust the airflow by rotating the bell, and start vaping.
Technical specifications
- Type: rebuildable dripper/BF atomizer
- Inhalation type: lung
- Construction materials: stainless steel
- Diameter: 26mm
- Height: 39.1mm (including drip tip)
- Liquid refill: dripping or bottom feeding
- Drip tip: 810
- Connector: 510
- Deck type: dual or triple coil
- Airflow control: side
Package contents
- 1 x Seri RDA Atomizer
- 1 x BF Pin
- 1 x Hex Key
- 1 x Screwdriver
- 1 x Short Circuit Connector (for dual coil)
- 3 x Prebuilt Ni80 0.2? Coils
- 3 x Cotton wicks
- 1 x Coil Leg Trimming Tool
- 1 x User Manual
- 1 x Spare Parts
Buy Hellvape atomizers at Svapoebasta
Take a look at the precious Hellvape atomizers and choose the one that suits you!
