Dall'1 Gennaio 2025 non sarà più possibile acquistare online i prodotti contenenti nicotina come da decreto legislativo del 26 Settembre 2024 N. 141. Sarà invece possibile acquistare online tutti i prodotti e varianti che non contengono nicotina.
Verify Age
To browse the site you must be at least 18 years old. Verify your age before accessing the site.
18+ only. Product containing nicotine, a highly addictive substance. Use not recommended for non-smokers.
Tomcat Bigass prefabricated coil Breakill's Alien Lab line Bullets for extreme cloud chasing (DL), only suitable for experienced vapers.
Ready-made coils made with 9 wraps on a 3.5mm complex wire in Ni80: suggested use in dual coil with a total resistance value of 0.34? (160-200W) on mechanical systems with stacked/series batteries and RDA atomizers 25mm and above.
The Tomcat Bigass from the Bullets line by Breakill's Alien Lab are ready-made resistors for cloud chasing to be used on mechanical systems with series batteries and on drippers with a minimum diameter of 25mm, exclusively for experienced vapers.
These large-sized resistors (slightly more contained than the Fat Man model) are made with 9 windings of wire in Nichrome 80 on a 3.5mm tip and have a resistance value of approximately 0.34 Ohm when used in pairs. The manufacturer's suggested wattage range for dual coil is 160-200W.
These resistors generate an immense amount of dense, persistent, and abundant vapor, guaranteeing a full and creamy aromatic yield. For a long lifespan (up to 400-700ml of liquid), it is recommended to perform a dry burn every 40-50ml.
The bullet-shaped metal package contains 2 coils.
Technical Specifications
Inhale type: lung (DL)
Material: Ni80
Number of windings: 9
Internal diameter: 3.5mm
Resistance value: 0.34? in dual coil
Wattage range: 160-200W in dual coil
Suggested atomizers: dual coil RDA of at least 25mm / box with series batteries
Dry burn: every 40-50ml
Estimated lifespan: 400-700ml
Instructions for Use
Place the two coils in the atomizer deck
Tighten the resistor legs in the appropriate anchor points
Trim the excess with wire cutters
Perform several dry activations at a low wattage (half of the recommended wattage) before inserting the cotton and verify that the glow of the windings is uniform (see tutorial)
Place a generous amount of cotton inside the coils and cut it to size, positioning it properly
Moisten the cotton with liquid and perform a few activations of the coil to verify its correct functioning
Close the atomizer and refill the liquid (for tanks)
Maintenance: perform a dry burn (dry activation without cotton) every 40-50ml of vaporized liquid
Package Contents
2 x Tomcat Bigass Coil Breakill's Alien Lab
1 x Metal package
All Breakill's Alien Lab ready-made resistors are available on Svapoebasta
On Svapoebasta you can buy these and many other Breakill ready-made resistors for rebuildable atomizers online.
