Auguse Era Pro RTA rebuildable atomizer for electronic cigarette - 4ml
The Era Pro by Auguse is a rebuildable atomizer with a diameter of 22mm made of stainless steel SS316L which is an evolution of the previous model Era RTA to offer excellent performance in cheek vaping.
The atomizer features a pyrex glass tank with a 4ml top-filling capacity and two drip tips that feed the coil from top to bottom; by rotating the tank, it is possible to open, close, or partially adjust the liquid flow to the coil.
Immediately below is the vaporization chamber, consisting of a single coil deck with dual airflow inlets: the coil is hit both from the bottom (where there is a fixed air pin with 3 1mm holes) and laterally, through two replaceable air pins. The package includes four pairs of side air pins: 2 x 0.8mm - 2 x 1.0mm - 2 x 1.2mm but also two blind air pins (without holes). The 4 screws on the deck allow you to install the coil facing up, down, or diagonally according to your needs.
In the lower part, there is an AFC ring that allows you to select one of the 7 airflow inlet holes available: 1.8 - 1.6 - 1.4 - 1.2 - 1.0 - 0.8 mm and a large slot (1.6 x 3.6mm). This allows for multiple airflow adjustments and a very precise customization of the draw contrast.
The 510 drip tip is composed of a metal base and core but covered with a transparent frosted polycarbonate sleeve. The package also includes a set of spare o-rings and gaskets and two prebuilt coils.
Thanks to the 510 connector, it can be installed on any box mod or tube with the same connection.
Instructions for use
- Detach the lower part of the atomizer by pulling it downwards
- Unscrew the ring with the drop symbols
- Detach the deck from the tank
- Build with the desired coil, insert cotton inside, and place the edges in the liquid wells
- Moisten the cotton with the desired e-liquid
- Reattach the tank section to the deck, screw the ring with the drops back on, and reinsert the airflow control ring
- Unscrew the top cap to access the refill compartment and fill the tank with e-liquid, then close it
- Rotate the tank to adjust the liquid flow to the coil (maximum opening when the circle under the glass aligns with the side air pin)
- Replace the side air pins on the bell as desired using a small flathead screwdriver
- Mount on a box mod and vape
- To adjust the draw: use the knurled ring at the base of the atomizer and/or replace the pin with one of the supplied pins
Technical specifications
- Type: rebuildable tank atomizer (RTA)
- Inhalation type: mouth-to-lung (MTL)
- Construction materials: stainless steel and polycarbonate
- Diameter: 22mm
- Height: 64.5mm (including drip tip)
- Weight: 68.5g
- Liquid capacity: 4ml
- Liquid refill: top fill
- Drip tip: 510
- Connector: 510
- Deck: single coil
- Included coils: two MTL pre-built coils
- Airflow control: side air pins and AFC ring
Package contents
- Era Pro RTA
- Spare Ultem tank
- Side air pins (2 x 0.8mm - 2 x 1.0mm - 2 x 1.2mm - 2 x blind)
- Spare deck o-rings and screws
- Two pre-built coils
All Auguse atomizers are available at Svapoebasta
At Svapoebasta you can find all the Auguse atomizers available on the manufacturer's official website.
